Archive

What To Do After Replacing Remote Batteries

After the batteries in your remote units have been replaced, you would need to send scan commands for the remote units to resume call-in. The remote unit goes into a high-power state for 3 days before they stop searching for the master unit. The scan commands that are sent within 3 days of replacing the […]

Remote Not Calling in After Replacing Batteries

After the batteries in your remote units have been replaced, scan commands need to be sent for the remote units to resume call-in, otherwise they will not be picked up again by the Master unit and will instead go on a high power state. When in this state, battery power is consumed at a high […]