Problem Cause 1 AC Power Adapter is not receiving power. Suggested Solution Check that the power outlet is energized and that the circuit breaker is not tripped. Check that the AC power plug is securely plugged into the electrical outlet. Problem Cause 2 Power link cable is disconnected. Suggested Solution Check that the AC power […]
When was Bin-Sense Plus released? April 2023. How often does a Bin-Sense Plus site/Automation Hub call in? Every 5 minutes (5 minutes, 20 seconds to be exact). In contrast, a Bin-Sense Live master calls in every 68 minutes. How does Bin-Sense Plus syStem get power? The Automation Hub needs to be plugged in to AC […]
After the batteries in your remote units have been replaced, you would need to send scan commands for the remote units to resume call-in. The remote unit goes into a high-power state for 3 days before they stop searching for the master unit. The scan commands that are sent within 3 days of replacing the […]
Click here for Bin-Sense Solo User Manual. For more manuals and guides, please visit our Support page.
For Bin-Sense Solo User Manual, please click here. Overview The Solo unit is used to automatically read up to four sensing cables once daily and send grain condition information to the Bin-Sense Mobile app using a cellular connection. Each bin to be monitored requires the installation of one Solo unit. Two different versions of Solo […]
Click here for the Bin-Sense Single Cable Installation Manual. For more manuals and guides, please visit our Support page.
Click here for the Bin-Sense Roof Bracket Installation Manual. For more manuals and guides, please visit our Support page.
Click here for the Bin-Sense Direct Quick Start Guide. For more manuals and guides, please visit our Support page.
Master The Master unit is your Bin-Sense Live system’s most critical component and serves as the core. It communicates to remotes and transmits data (e.g. temperature / moisture readings) to the Bin-Sense servers via cellular connection. If none of your bins are reporting, it is likely that the Master unit is experiencing issues. Troubleshooting Login […]
After the batteries in your remote units have been replaced, scan commands need to be sent for the remote units to resume call-in, otherwise they will not be picked up again by the Master unit and will instead go on a high power state. When in this state, battery power is consumed at a high […]
