Archive

No Ambient Sensor Readings

Possible Cause 1 Sensor link cable is disconnected. Suggestion Solution Check that the Ambient Sensor link cable is securely connected to the Automation Hub sensor link cable. Check that the sensor link cable is plugged into connection J1 on the Automation Hub circuit board. Possible Cause 2 Defective or incorrectly configured Ambient Sensor. Suggested Solution […]

Remote Not Calling in After Replacing Batteries

After the batteries in your remote units have been replaced, scan commands need to be sent for the remote units to resume call-in, otherwise they will not be picked up again by the Master unit and will instead go on a high power state. When in this state, battery power is consumed at a high […]